1.INSPECT TIRES
Inspect the tires (see page Drivetrain>TIRE AND WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION).
2.MEASURE VEHICLE HEIGHT
Measure the vehicle height (see page Suspension>SUSPENSION>FRONT WHEEL ALIGNMENT>ADJUSTMENT).
3.INSPECT TOE-IN
| A + B | C - D |
|---|---|
| 0°17' +-22' (0.28° +-0.37°) | 3.3 +-4.0 mm (0.13 +-0.16 in.) |
If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.
4.INSPECT CAMBER
Install the camber-caster-kingpin gauge or set the vehicle on the wheel alignment tester.
Inspect the camber.
| Item | Specified Condition |
|---|---|
| Camber
Right-left error |
-1°24' +-30' (-1.40° +-0.5°)
30' (0.5°) or less |
The camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.