Home › Suspension › SUSPENSION › FRONT SHOCK ABSORBER
RM24M0E _53 Suspension _059582 SUSPENSION _0292150 FRONT SHOCK ABSORBER A

SUSPENSION  FRONT SHOCK ABSORBER  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedures for the RH side and LH side.

·

The procedures listed below are for the LH side.



PROCEDURE

Hide 48681B 1.INSTALL FRONT SUSPENSION SUPPORT GASKET LH

a.

Install the support gasket.


Hide 2.INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING

a.
C133551

Install the front shock absorber with coil spring (upper side) with the 3 nuts.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


b.
C367473

Install the front shock absorber with coil spring to the steering knuckle with the 2 bolts and 2 nuts.

T = 240 N*m{ 2,447 kgf*cm 177 ft.*lbf }

NOTICE:

Do not tighten the bolts.



c.
C135499

Fully tighten the front support to front shock absorber nut.

Torque:
47 N*m (479 kgf*cm, 35 ft.*lbf)


Hide 48684B 3.INSTALL FRONT SUSPENSION SUPPORT DUST COVER LH

a.

Install the dust cover to the shock absorber.


Hide 48810 4.INSTALL FRONT STABILIZER LINK ASSEMBLY LH

Hide 6.INSTALL FRONT WHEEL

T = 103 N*m{ 1,050 kgf*cm 76 ft.*lbf }

Hide 7.STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Press down on the vehicle several times to stabilize the suspension.


Hide 8.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

a.

Inspect and adjust front wheel alignment (see page Suspension>SUSPENSION>FRONT WHEEL ALIGNMENT>ADJUSTMENT).