1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2.REMOVE FRONT WHEEL
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
51442
4.REMOVE NO. 2 ENGINE UNDER COVER
53702
5.REMOVE FRONT FENDER APRON SUB-ASSEMBLY LH
53701
6.REMOVE FRONT FENDER APRON SUB-ASSEMBLY RH
53301
7.REMOVE HOOD SUB-ASSEMBLY
45259A
8.REMOVE COLUMN HOLE COVER SILENCER SHEET
45260
9.SEPARATE NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY
12371A
10.REMOVE REAR ENGINE MOUNTING INSULATOR
48810
11.REMOVE FRONT STABILIZER LINK ASSEMBLY LH
48820B
12.REMOVE FRONT STABILIZER LINK ASSEMBLY RH
48069
13.SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH
Remove the 2 nuts and bolt, and disconnect the lower arm from the ball joint.
48068
14.SEPARATE FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY RH
Use the same procedures described for the LH side.
51201
15.SEPARATE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Remove the bolt from the suspension member.
Support the crossmember with a jack.
Remove the bolts labeled A.
Remove the 4 bolts from the member reinforcement.
Remove the bolts labeled B.
Remove the 6 bolts from the member brace.
Slowly lower the jack, and disconnect the crossmember from the vehicle.
48069
16.REMOVE FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY LH
Remove the bolt from the suspension member (front side).
Remove the bolt and nut from the suspension member (rear side). Then remove the lower arm.
48068
17.REMOVE FRONT SUSPENSION LOWER NO. 1 ARM SUB-ASSEMBLY RH
Use the same procedures described for the LH side.