1.CHECK BRAKE PEDAL LOAD SENSING SWITCH
Do not remove the brake pedal load sensing switch from the brake pedal support.
When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.
Disconnect the brake pedal load sensing switch connector.
Measure the resistance of the switch.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1 - 2 | Brake pedal depressed | Approx. 1 kΩ |
| 1 - 2 | Brake pedal released | Approx. 213 Ω |
If the value is not as specified, replace the brake pedal support assembly (see page Brake>BRAKE>BRAKE PEDAL>REMOVAL).