Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292157 ANTI-LOCK BRAKE SYSTEM L

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  PRECAUTION  


NOTICE FOR INITIALIZATION


NOTICE:

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.


System Name See procedure
Lighting System (Click here)
Parking Assist Monitor System
Power Slide Door System
Power Back Door System


TROUBLESHOOTING PRECAUTION



·

When there are problems with contact points of terminals and improper part installation, the installation/removal of the suspected part may return the system to normal or may only temporarily return the system to normal.

·

To determine the malfunctioning area, use DTCs, freeze frame data and other data to help determine conditions at the time of the malfunction. Write down the data before disconnecting connectors or installing/removing parts.

·

The Anti-lock Brake System (ABS) may be affected by malfunctions in other systems. Check for DTCs in other systems and, if present, troubleshoot those DTCs first.

·

Unless specified, the engine switch must be off when installing / removing the brake actuator and the ABS connectors.

·

After the brake actuator or an ABS connector has been removed and reinstalled, be sure to check for DTCs. Also, perform the test mode inspection to make sure the part is functioning normally.

·

If the DTC of the CAN communication line is output, repair the malfunction in the communication line and then troubleshoot the ABS.

·

Since the CAN communication line has its own length and route, it cannot be repaired temporarily with a by-pass wire, etc.