If the vehicle is stationary during sensor check mode, speed sensor malfunctions cannot be detected. The vehicle must be driven for speed sensor malfunctions to be detected.
Change to sensor check mode by connecting terminals TS and CG of the DLC3, and turning the engine switch from off to on (IG).
Disconnect the A22 ECU connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
|---|---|
| G15-4 (CG) - Body ground | Below 1 Ω |
| G15-12 (TS) - A22-25 (TS) | Below 1 Ω |
| A22-25 (TS) - Body ground | 10 kΩ or higher |
OK
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>BRAKE ACTUATOR(for 2AZ-FE without VSC)>REMOVAL)
NG