Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(for 2AZ-FE without VSC) › 2013.04–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292159 BRAKE ACTUATOR(for 2AZ-FE without VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(for 2AZ-FE without VSC)  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 74431 3.REMOVE BATTERY TRAY

Hide 17705 4.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

Hide 17700 5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY

Hide 6.DRAIN BRAKE FLUID

NOTICE:

Wash off brake fluid immediately if it comes in contact with any painted surface.


Hide 7.DISCONNECT BRAKE LINES

a.
C130690

Using SST, disconnect the 6 brake tubes from the brake actuator assembly.

SST
09023-00101  


b.
C130691E02
2.208,3.302 2.542,4.094 2.542,4.094 2.698,2.875 true 1.927,1.802 2.042,1.708 false 1.698,1.479 1.969,1.281 false 1.479,1.115 1.781,0.833 false 1.271,0.708 1.552,0.406 false 2.083,1.604 3.177,1.792 1.094,0.188 10 false Front Wheel RH 1.833,0.729 2.875,0.917 1.042,0.188 10 false Rear Wheel RH 2.01,1.167 3.042,1.354 1.031,0.188 10 false Rear Wheel LH 2.094,4.135 3.167,4.375 1.073,0.24 10 false Master Cylinder 1.594,0.323 2.615,0.51 1.021,0.188 10 false Front Wheel LH

Place tags or marks to identify the installation locations of each brake line.


Hide 44510 8.REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRACKET

a.
C130692

Pull the lock lever upward and disconnect the connector.


b.
C133748

Disconnect the brake tube clamp from the bracket.


c.
C130693

Remove the 3 nuts and brake actuator assembly with bracket.

NOTICE:

Be careful not to damage the brake lines.