Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1201/51  Engine Control System Malfunction  


DESCRIPTION

If a malfunction in the engine control system is detected, the operations of VSC and TRC are prohibited by the fail-safe function. When the signals from the engine are input normally, the fail-safe is canceled and the DTC is not stored.

DTC No. DTC Detection Condition Trouble Area
C1201/51 Engine control system malfunction signal continues for 5 seconds. Engine control system

CAUTION / NOTICE / HINT

NOTICE:

When replacing the ECM, perform yaw rate sensor zero point calibration first, and then CVT oil pressure calibration (See page Drivetrain>K112 (CVT)>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION).


PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (MOMENTARY INTERRUPTION)
a.

Using the Data list of the intelligent tester, check for any momentary interruption in the wire harness corresponding to the DTC (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CHECK FOR INTERMITTENT PROBLEMS).

ABS/VSC/TRC
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
EFI Communication Open EFI communication open detection / ERROR or NORMAL ERROR: Momentary interruption
NORMAL: Normal
-

OK:

There are no momentary interruptions.


HINT:

Perform the above inspection before removing the sensor and connector.




OK

2.CHECK DTC FOR ENGINE CONTROL SYSTEM

NG

3.REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - SKID CONTROL ECU)
2.CHECK DTC FOR ENGINE CONTROL SYSTEM
a.

Clear the DTC (engine control system).


b.

Check the DTC (engine control system).

Result
Result Proceed to
DTC is output A
DTC is not output B



A

REPAIR ENGINE CONTROL SYSTEM

B

REPLACE ECM

3.REPAIR OR REPLACE HARNESS OR CONNECTOR (ECM - SKID CONTROL ECU)

NEXT

4.RECONFIRM DTC
4.RECONFIRM DTC

b.

Perform a road test.


c.

Check if the same DTC is recorded (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC C1201/51 is output B



A

END

B

2.CHECK DTC FOR ENGINE CONTROL SYSTEM