FAIL SAFE OPERATION
If there is a problem with any sensor signals or actuator systems, the skid control ECU prohibits the power supply to the ABS and TRACTION actuator and informs the ECM of VSC system failure.
The ABS and TRACTION actuator turns off the solenoids and the ECM shuts off VSC control (traction control signal) from the skid control ECU accordingly, the result being that it is as if the ABS, TRC and VSC systems were not installed.
ABS control is prohibited, but EBD control continues as far as possible. If EBD control is impossible, the brake warning light comes on to warn the driver (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSIS SYSTEM).
If system components have any malfunctions before starting control, the operation stops immediately. If system components have any malfunctions during control, the control stops gradually so as not to trigger a sudden change in vehicle conditions.
If it is impossible to control the systems, the warning light comes on to inform the driver of malfunctions in the systems (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSIS SYSTEM).
If the ABS system malfunctions, the brake system operates normally without the ABS system.
If the ABS and TRACTION actuator malfunctions, a gradual loss of brake performance is expected, and ABS system control is prohibited.
| Malfunction Area | Fail-Safe Operation |
|---|---|
| ABS system | ABS, TRC and VSC control prohibited |
| EBD system | ABS, EBD, TRC and VSC control prohibited |
| Malfunction Area | Fail-Safe Operation |
|---|---|
| Engine control system
(TRC and VSC systems) |
Before control: Disables control
During control: Uses only the brakes to effect control |
| Brake control system
(VSC system) |
Before control: Disables control
During control: Uses only the engine to effect control |
| Brake control system
(TRC system) |
Before control: Disables control
During control: Disables control (by gradually ending control) |