Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  DIAGNOSIS SYSTEM  


DIAGNOSIS


a.

If the skid control ECU detects a malfunction, the ABS, brake warning lights and the slip indicator light will come on in order to warn the driver.


b.

The DTCs can be read by connecting SST (09843-18040) between the TC and CG terminals of the DLC3 and observing the blinking pattern of the ABS warning light and slip indicator light or by using the intelligent tester (see page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).




CHECK WARNING LIGHT AND INDICATOR LIGHT


a.

Release the parking brake lever.

NOTICE:

Before releasing the parking brake lever, set chocks to hold the vehicle for safety.


HINT:

When the parking brake is applied or the brake fluid level is low, the brake warning light comes on.



b.

When the engine switch is turned on (IG), check that the ABS, brake warning lights and TRC OFF, VSC OFF, slip indicator lights come on and go off in about 3 seconds.

HINT:

If the warning lights do not illuminate, confirm whether the bulbs have burned out, and also check for CAN communication system DTCs, since the skid control ECU and combination meter are connected by the CAN communication line.

If the warning light remains on, perform relevant troubleshooting procedures. The relevant troubleshooting procedures are in the sections listed in the table below.

Section Title See procedure
ABS Warning Light Remains ON (Click here)
Brake Warning Light Remains ON (Click here)
Slip Indicator Light Remains ON (Click here)