This DTC is stored when the skid control ECU (brake actuator assembly) detects an abnormality in the difference between the acceleration sensor value and the control value estimated based on the yaw rate sensor, steering angle sensor and speed sensor signals.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1420 | Acceleration Sensor Malfunction | The difference between the acceleration sensor value and the control value estimated inside the skid control ECU (brake actuator assembly) is abnormal. | ·
Sensor installation ·
Acceleration sensor (yaw rate and acceleration sensor) |
When replacing the yaw rate and acceleration sensor, perform acceleration sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Check that the yaw rate and acceleration sensor has been installed properly (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION).
The yaw rate and acceleration sensor is tightened to the specified torque.
The yaw rate and acceleration sensor is not installed in a tilted position.
If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
OK
NG
(See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>YAW RATE AND DECELERATION SENSOR>INSTALLATION)