Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2014.09–2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page.

NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensors, etc., turn the engine switch off.


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Vehicle Stability Control System
Symptom Suspected Area See page
ABS, BA and/or EBD does not operate Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) (Click here)
Power source circuit (low power supply voltage malfunction) (Click here)
Power source circuit (high power supply voltage malfunction) (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Check the brake actuator assembly using the GTS. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). (Click here)
ABS, BA and/or EBD does not operate efficiently Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.). (Click here)
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Stop light switch circuit (on stuck malfunction) (Click here)
Stop light switch circuit (open malfunction) (Click here)
Stop light switch circuit (off stuck malfunction) (Click here)
Check the brake actuator assembly using the GTS. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). (Click here)
ABS sensor DTC check cannot be done Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) (Click here)
TC and CG terminal circuit (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). (Click here)
ABS warning light abnormal (Remains on) ABS warning light circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)
ABS warning light abnormal (Does not come on) ABS warning light circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)
Brake warning light abnormal (Remains on) Brake warning light circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)
Brake warning light abnormal (Does not come on) Brake warning light circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)
VSC and/or TRC does not operate Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) (Click here)
Check system variant learning. (Click here)
Check the engine control system. (Click here)
Power source circuit (low power supply voltage malfunction) (Click here)
Power source circuit (high power supply voltage malfunction) (Click here)
Check the hydraulic circuit for leaks. -
Front speed sensor circuit (Click here)
Rear speed sensor circuit (Click here)
Yaw rate and acceleration sensor circuit (sensor malfunction) (Click here)
Yaw rate and acceleration sensor circuit (power supply voltage malfunction) (Click here)
Acceleration sensor circuit (comparison malfunction) (Click here)
Yaw rate sensor circuit (comparison malfunction) (Click here)
Yaw rate and acceleration sensor circuit (internal malfunction) (Click here)
Steering angle sensor circuit (output malfunction) (Click here)
Steering angle sensor circuit (power source voltage malfunction) (Click here)
Steering angle sensor circuit (internal malfunction) (Click here)
Replace the ECM (for 2AZ-FE). (Click here)
Replace the ECM (for 2GR-FE). (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). (Click here)
VSC sensor DTC check cannot be done Check again to see if DTCs are output. (If DTCs are output, perform diagnosis based on the DTCs that are output.) (Click here)
TC and CG terminal circuit (Click here)
If the symptoms still occur even after the above suspected areas have been inspected and proved to be normal, replace the skid control ECU (brake actuator assembly). (Click here)
VSC OFF switch abnormal VSC OFF switch circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)
Slip indicator light abnormal (Remains on) Slip indicator light circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)
Slip indicator light abnormal (Does not come on) Slip indicator light circuit (Click here)
Skid control ECU (Brake actuator assembly) (Click here)