Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1224  NE Signal  


DESCRIPTION

The skid control ECU (brake actuator assembly) receives engine speed signals from the ECM via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1224 NE Signal The vehicle speed is 6 km/h (4 mph) or more, the +BS terminal voltage is between 9.6 and 16.5 V, and the engine speed signal is more than 12800 rpm for 2.5 seconds or more.
·

CAN communication system

·

ECM



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.CHECK SFI SYSTEM

B

2.CHECK SFI SYSTEM

Result:
Result Proceed to
DTCs are not output (for 2AZ-FE). A
DTCs are not output (for 2GR-FE). B
DTCs are output (for 2AZ-FE). C
DTCs are output (for 2GR-FE). D



A

B

C

D