Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › from 2016.05
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1288  Error in Matching of ECUs  


DESCRIPTION

The skid control ECU (brake actuator assembly) stores this DTC when the previously learned values in the VSC system and engine information sent from the ECM are inconsistent, or when the learning has not completed after the skid control ECU (brake actuator assembly) is replaced with a new one.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1288 Error in Matching of ECUs ECM does not match. ECM

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication system DTCs are output (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).


Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B



A

2.PERFORM SYSTEM VARIANT LEARNING

B

2.PERFORM SYSTEM VARIANT LEARNING
a.

Perform system variant learning (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).

HINT:
·

System variant learning is automatically performed immediately after Test Mode is entered.

·

If learning has not yet been performed, the slip indicator light will remain on and DTC C1288 will be stored.

·

If system variant learning is not successful, the warning lights will not blink in the Test Mode pattern and DTC C1288 will not be cleared.





NEXT

3.RECONFIRM DTC
3.RECONFIRM DTC
a.

Turn the engine switch off.



c.

Turn the engine switch off.


d.

Start the engine.


e.

Check if the same DTC is output (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTC C1288 is not output. A
DTC C1288 is output (for 2AZ-FE). B
DTC C1288 is output (for 2GR-FE). C


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).




A

END

B

C