Home › Vehicle Interior › AIR CONDITIONING › REAR COOLING UNIT
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292173 REAR COOLING UNIT A

AIR CONDITIONING  REAR COOLING UNIT  INSTALLATION  


PROCEDURE

Hide 87215H 1.INSTALL NO. 3 AIR DUCT REAR (for Automatic Air Conditioning System)

E131028

a.

Install the duct with the 2 screws.


Hide 2.INSTALL REAR COOLING UNIT ASSEMBLY

E360173

a.

Install the cooling unit with the 4 bolts.


b.

Connect the 2 clamps and 2 connectors.


c.
E131026

Install the 2 bolts.

Torque:
9.8 N*m (100 kgf*cm, 7 ft.*lbf)


Hide 88566A 3.INSTALL NO. 1 COOLER AIR DUCT

Hide 4.INSTALL COOLER PLATE

Hide 88717A 5.INSTALL COOLER REFRIGERANT SUCTION PIPE A

E133198

a.

Sufficiently apply compressor oil to new 2 O-rings and the fitting surface of the suction pipe.

Compressor oil:

ND-OIL 8 or equivalent



b.

Install the O-ring on the suction pipe.


c.

Install the suction pipe with the bolt

Torque:
9.8 N*m (100 kgf*cm, 7 ft.*lbf)


Hide 88716B 6.INSTALL COOLER REFRIGERANT LIQUID PIPE B

E131024

a.

Sufficiently apply compressor oil to new 2 O-rings and the fitting surface of the liquid pipe.

Compressor oil:

ND-OIL 8 or equivalent



b.

Install the O-ring on the liquid pipe.


c.

Install the liquid pipe with the bolt

Torque:
9.8 N*m (100 kgf*cm, 7 ft.*lbf)


Hide 87255B 7.INSTALL REAR HEATER WATER INLET HOSE B

Hide 87256B 8.INSTALL REAR HEATER WATER OUTLET HOSE B

Hide 65637B 9.INSTALL REAR WHEEL HOUSE LINER RH

E131022

a.

Install the wheel house liner with the 7 nuts.


Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 11.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

Hide 14.PERFORM INITIALIZATION

a.

Perform initialization (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.