Home › Vehicle Interior › AIR CONDITIONING › PTC HEATER RELAY(for Cold Area)
RM24M0E _58 Vehicle Interior _059584 AIR CONDITIONING _0292179 PTC HEATER RELAY(for Cold Area) G

AIR CONDITIONING  PTC HEATER RELAY(for Cold Area)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 87346K 2.REMOVE PTC HEATER RELAY

E133843

a.

Remove the 3 PTC heater relays to the engine room No. 2 relay block.


Hide 3.INSPECT PTC HEATER RELAY

A395833E01
2.344,0.792 2.656,0.469 false 2.063,1.771 2.354,1.448 false 1.635,1.115 1.958,1.115 false 2.667,1.115 2.99,1.115 false 0.292,1.323 0.604,1.521 0.313,0.198 10 false 1 0.292,0.781 0.604,0.979 0.313,0.198 10 false 3 1.302,0.781 1.615,0.979 0.313,0.198 10 false 5 1.292,1.313 1.604,1.51 0.313,0.198 10 false 2 1.906,1.74 2.219,1.938 0.313,0.198 10 false 2 2.677,0.333 2.99,0.531 0.313,0.198 10 false 1 1.5,1.031 1.813,1.229 0.313,0.198 10 false 3 3.052,1.031 3.365,1.229 0.313,0.198 10 false 5

a.

Measure the resistance of the relay.

Standard resistance:
Tester Connection Specified Condition
3 - 5 10 kΩ or higher
3 - 5 Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)


If the result is not as specified, replace the relay.



Hide 87346K 4.INSTALL PTC HEATER RELAY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.