Home › Vehicle Interior › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM
RM24M0E _58 Vehicle Interior _059586 ENGINE IMMOBILISER _0292196 ENGINE IMMOBILISER SYSTEM U

ENGINE IMMOBILISER  ENGINE IMMOBILISER SYSTEM  DATA LIST / ACTIVE TEST  


READ DATA LIST


HINT:

Using the intelligent tester's Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to save time.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch on (IG) and turn the tester ON.


c.

Select the following menu items: Body / Immobiliser / Data List.


d.

Check the results by referring to the table below.



Certification ECU:
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Ignition Switch Ignition switch on (IG) signal / ON or OFF ON: Ignition switch on (ACC, IG) or start
OFF: Ignition switch off
-
ACC Switch Ignition switch on (ACC) signal / ON or OFF ON: Ignition switch on (ACC, IG) or start
OFF: Ignition switch off
-
ID-BOX Sleep Condition ID code box sleep condition / YES or NO - -
ID-BOX Start Condition ID code box wake up signal / YES or NO - -
EFI Code Receive SFI code receive / OK or NG OK: SFI code is received
NG: SFI code is not received
-
Engine Start Request ID code box start request condition / OK or NG OK: Start request condition signal is received
NG: Start request condition signal is not received
-
3bit Code Request 3 bit code request / OK or NG OK: 3 bit code is received
NG: 3 bit code is not received
-
S Code Check Code verification result / OK or NG OK: Verification confirmed
NG: Verification is not confirmed
-
L Code Check Code verification result / OK or NG OK: Verification confirmed
NG: Verification is not confirmed
-