ENGINE IMMOBILISER
ENGINE IMMOBILISER SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- PROBLEM SYMPTOMS TABLE2013.04–2014.092014.09–2016.05from 2016.05
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- B2784 Antenna coil open/short
- B2785 LIN communication from certification ECU stops for specified amount of time
- B2789 Certification ECU does not receive LIN communication signals from ID code box via LIN for 10 seconds
- B278A Engine switch power source supply line is open or short
- B2790 ID code box detects internal malfunction
- B2791 One of following conditions is met: · Communication failure between ID code box and ECM · Communication line...
- B2799 One of following conditions is met: · Error in communication between ECM and ID code box · Error in...
- B279A When communication line (EFIO - IMI) between ECM and ID code box (immobiliser code ECU) is stuck on HI output.
- B279C When ECM that is incompatible with engine immobiliser system is installed.2013.04–2016.05from 2016.05
- ID Code Box Power Source Circuit
- Certification ECU Power Source Circuit