Home › Vehicle Interior › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM
RM24M0E _58 Vehicle Interior _059586 ENGINE IMMOBILISER _0292196 ENGINE IMMOBILISER SYSTEM C

ENGINE IMMOBILISER  ENGINE IMMOBILISER SYSTEM  B278A  Short to GND in Immobiliser System Power Source Circuit  


DESCRIPTION

This DTC is output when the engine switch power source supply line is open or short.

DTC No. DTC Detection Condition Trouble Area
B278A Engine switch power source supply line is open or short
·

Wire harness

·

Engine switch

·

Certification ECU



WIRING DIAGRAM

B144267E07
5.26,2 6.438,2.375 1.177,0.375 10 false G29 0.74,1.958 1.677,2.344 0.938,0.385 10 false G31 1.229,0.865 1.594,1.073 0.365,0.208 10 false VC5 1.635,0.75 1.823,0.958 0.188,0.208 10 false 14 5.344,0.833 5.708,1.042 0.365,0.208 10 false VC5 5.052,0.75 5.24,0.917 0.188,0.167 10 false 30 1.115,1.49 1.594,1.698 0.479,0.208 10 false AGND 1.635,1.354 1.781,1.563 0.146,0.208 10 false 8 5.344,1.458 5.781,1.667 0.438,0.208 10 false AGND 5.052,1.375 5.24,1.542 0.188,0.167 10 false 40 0.74,2.115 1.677,2.5 0.938,0.385 10 false Engine Switch 5.271,2.177 6.448,2.552 1.177,0.375 10 false Certification ECU

PROCEDURE

1.CHECK WIRE HARNESS (CERTIFICATION ECU - ENGINE SWITCH)
U188565E02
2.406,2.073 2.188,2.448 true 6.292,2.135 6.448,2.49 true 5.521,2.135 5.396,2.448 true 3.76,2.063 3.938,2.354 true 6.5,2.448 6.844,2.646 0.344,0.198 10 false VC5 4.927,2.375 5.427,2.573 0.5,0.198 10 false AGND 1.958,2.5 2.302,2.698 0.344,0.198 10 false VC5 3.865,2.417 4.365,2.615 0.5,0.198 10 false AGND 0.125,0.104 1.698,0.313 1.573,0.208 10 false Wire Harness Side: 1.781,1.031 3.083,1.24 1.302,0.208 10 false Certification ECU 5.458,1.167 6.563,1.375 1.104,0.208 10 false Engine Switch 0.177,1.781 0.49,1.979 0.313,0.198 10 false G29 4.917,1.823 5.208,2.021 0.292,0.198 10 false G31

a.

Disconnect the G29 ECU connector.


b.

Disconnect the G31 switch connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
Tester Connection Specified Condition
G29-30 (VC5) - G31-14 (VC5) Below 1 Ω
G29-40 (AGND) - G31-8 (AGND)
G29-30 (VC5) or G31-14 (VC5) - Body ground 10 kΩ or higher
G29-40 (AGND) or G31-8 (AGND) - Body ground




OK

2.CHECK ENGINE SWITCH (OPERATION)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK ENGINE SWITCH (OPERATION)
a.

Temporarily replace the engine switch with a new or normally functioning one.


b.

Check that the engine starts normally.

OK:

Engine starts normally.




OK

END (ENGINE SWITCH IS DEFECTIVE)

NG

REPLACE CERTIFICATION ECU