Home › Vehicle Interior › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM
RM24M0E _58 Vehicle Interior _059586 ENGINE IMMOBILISER _0292196 ENGINE IMMOBILISER SYSTEM J

ENGINE IMMOBILISER  ENGINE IMMOBILISER SYSTEM  ID Code Box Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the ID code box.

WIRING DIAGRAM

B144268E01
5.403,3.424 6.364,3.912 0.961,0.488 10 G20 ID Code Box 5.391,1.217 5.774,1.434 0.383,0.217 10 +B 5.169,1.109 5.325,1.326 0.156,0.217 10 1 5.169,2.419 5.325,2.637 0.156,0.217 10 8 2.982,1.39 3.619,1.607 0.637,0.217 10 ECU-B3 1.139,2.285 2.067,2.502 0.928,0.217 10 RH R/B BATT 1.139,3.451 1.771,3.669 0.632,0.217 10 FL MAIN 1.292,4.558 1.848,4.775 0.556,0.217 10 Battery 5.391,2.515 5.774,2.732 0.383,0.217 10 GND

PROCEDURE

1.INSPECT FUSE (ECU-B3)
a.

Remove the ECU-B3 fuse from the engine room No. 2 relay block.


b.

Measure the resistance of the fuse.

Standard resistance:

Below 1 Ω




OK

2.CHECK WIRE HARNESS (ID CODE BOX - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK WIRE HARNESS (ID CODE BOX - BATTERY AND BODY GROUND)
U188554E02
0.969,2.51 1.125,2.24 true 2.469,2.51 2.292,2.24 true 0.771,2.552 1,2.75 0.229,0.198 10 false +B 2.469,2.531 2.854,2.729 0.385,0.198 10 false GND 0.104,0.094 1.656,0.354 1.552,0.26 10 false Wire Harness Side: 1.563,1.073 1.854,1.271 0.292,0.198 10 false G20

a.

Disconnect the G20 box connector.


b.

Measure the resistance and voltage of the wire harness side connector.

Standard resistance:
Tester Connection Specified Condition
G20-8 (GND) - Body ground Below 1 Ω


Standard voltage:
Tester Connection Specified Condition
G20-1 (+B) - Body ground 10 to 14 V




OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR