Home › Vehicle Interior › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM
RM24M0E _58 Vehicle Interior _059586 ENGINE IMMOBILISER _0292196 ENGINE IMMOBILISER SYSTEM J

ENGINE IMMOBILISER  ENGINE IMMOBILISER SYSTEM  Certification ECU Power Source Circuit  


DESCRIPTION

This circuit provides power to operate the certification ECU.

WIRING DIAGRAM

B144268E02
5.316,3.428 6.466,3.916 1.150,0.488 10 G29 Certification ECU 5.382,1.221 5.766,1.438 0.383,0.217 10 +B 5.16,1.113 5.316,1.330 0.156,0.217 10 1 5.109,2.423 5.316,2.641 0.206,0.217 10 17 2.974,1.394 3.611,1.611 0.637,0.217 10 ECU-B3 1.13,2.289 2.059,2.506 0.928,0.217 10 RH R/B BATT 1.13,3.455 1.762,3.673 0.632,0.217 10 FL MAIN 1.283,4.562 1.839,4.779 0.556,0.217 10 Battery 5.394,2.519 5.578,2.736 0.184,0.217 10 E

PROCEDURE

1.INSPECT FUSE (ECU-B3)
a.

Remove the ECU-B3 fuse from the engine room No. 2 relay block.


b.

Measure the resistance of the fuse.

Standard resistance:

Below 1 Ω




OK

2.CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

2.CHECK WIRE HARNESS (CERTIFICATION ECU - BATTERY AND BODY GROUND)
U188555E02
0.198,2.458 0.302,1.99 true 3.26,2.448 3.156,1.979 true 0.083,2.5 0.406,2.698 0.323,0.198 10 false +B 3.24,2.51 3.365,2.708 0.125,0.198 10 false E 0.156,0.115 1.688,0.333 1.531,0.219 10 false Wire Harness Side: 1.677,1.073 1.99,1.271 0.313,0.198 10 false G29

a.

Disconnect the G29 ECU connector.


b.

Measure the resistance and voltage of the wire harness side connector.

Standard resistance:
Tester Connection Specified Condition
G29-17 (E) - Body ground Below 1 Ω


Standard voltage:
Tester Connection Specified Condition
G29-1 (+B) - Body ground 10 to 14 V




OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR