NOTICE FOR INITIALIZATION
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System Name | See procedure |
|---|---|
| Lighting System | ( )
|
| Parking Assist Monitor System | |
| Power Slide Door System | |
| Power Back Door System |
PRECAUTIONS WHEN USING INTELLIGENT TESTER
When using the intelligent tester to troubleshoot the LIN communication line: Connect the intelligent tester to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.
After all DTCs are cleared, check if the trouble occurs again 6 seconds after the ignition switch is turned on (IG).