28800
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
55404C
2.REMOVE INSTRUMENT CLUSTER FINISH PANEL
83855
3.REMOVE NO. 1 COMBINATION METER BRACKET
Remove the 3 screws and bracket.
83856
4.REMOVE NO. 2 COMBINATION METER BRACKET
Remove the 3 screws and bracket.
83809
5.REMOVE COMBINATION METER SUB-ASSEMBLY
Apply protective tape under the instrument panel as shown in the illustration.
Remove the 2 screws.
Disconnect the connector.
Lift up the combination meter in the direction of the arrow shown in the illustration, and detach the 2 clips.
Rotate the combination meter into the upper instrument panel in the direction of arrow A.
Pull out the left end of the combination meter in the direction of arrow B.
Slide the combination meter in the direction of arrow C, and pull it out from the upper instrument panel.
Slide the combination meter in the direction of arrow D, and remove the meter.