Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › 2013.04–2014.09
RM24M0E _56 Audio / Visual / Telematics _059588 NAVIGATION / MULTI INFO DISPLAY _0292199 NAVIGATION SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the navigation receiver assembly.

WIRING DIAGRAM

E226166E60
3.692,0.996 3.821,1.163 0.129,0.167 10 1 5.213,0.98 5.342,1.146 0.129,0.167 10 6 5.11,1.958 5.428,2.125 0.318,0.166 10 F18 2.665,1.379 2.966,1.546 0.301,0.166 10 A4 2.665,1.548 3.794,1.929 1.129,0.381 10 Parking Brake Switch Assembly 5.412,1.089 5.766,1.270 0.354,0.181 10 PKB 5.112,2.113 6.377,2.455 1.265,0.342 10 Navigation Receiver Assembly

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.




OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - NAVIGATION RECEIVER ASSEMBLY)
a.

Disconnect the F18 navigation receiver assembly connector.


b.

Disconnect the A4 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F18-6 (PKB) - A4-1 Always Below 1 Ω
F18-6 (PKB) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR