Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM › 2013.04–2014.09
RM24M0E _54 Brake _059583 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0292158 VEHICLE STABILITY CONTROL SYSTEM T

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of the problem symptom. The potential causes of the symptoms are listed in order of probability in the "Suspected area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



NOTICE:

When replacing the ABS and TRACTION actuator or sensor, turn the engine switch off.


Vehicle stability control system:
Symptom Suspected Area See page
ABS, BA and/or EBD does not operate 1. Check for DTCs again and make sure that normal system code displayed. (Click here)
2. IG power source circuit (Click here)
3. Front speed sensor circuit (Click here)
4. Rear speed sensor circuit (Click here)
5. Check ABS and TRACTION actuator using intelligent tester (Check ABS and TRACTION actuator operation using ACTIVE TEST function). If abnormal, check hydraulic circuit for leakage (for 2AZ-FE). (Click here)
6. Check ABS and TRACTION actuator using intelligent tester (Check ABS and TRACTION actuator operation using ACTIVE TEST function). If abnormal, check hydraulic circuit for leakage (for 2GR-FE). (Click here)
7. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE). (Click here)
8. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2GR-FE). (Click here)
ABS, BA and/or EBD does not operate efficiently 1. Check for DTCs again and make sure that normal system code displayed. (Click here)
2. Front speed sensor circuit (Click here)
3. Rear speed sensor circuit (Click here)
4. Stop light switch circuit (Stuck on malfunction) (Click here)
5. Stop light switch circuit (Open malfunction) (Click here)
6. Stop light switch circuit (Stuck off malfunction) (Click here)
7. Check ABS and TRACTION actuator using intelligent tester (Check ABS and TRACTION actuator operation using ACTIVE TEST function). If abnormal, check hydraulic circuit for leakage (for 2AZ-FE). (Click here)
8. Check ABS and TRACTION actuator using intelligent tester (Check ABS and TRACTION actuator operation using ACTIVE TEST function). If abnormal, check hydraulic circuit for leakage (for 2GR-FE). (Click here)
9. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE). (Click here)
10. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2GR-FE). (Click here)
VSC and/or TRC does not operate 1. Check for DTCs again and make sure that normal system code displayed. (Click here)
2. IG power source circuit (Click here)
3. Check hydraulic circuit for leakage. -
4. Front speed sensor circuit (Click here)
5. Rear speed sensor circuit (Click here)
6. Yaw rate sensor circuit (Click here)
7. Steering angle sensor circuit (Click here)
8. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE). (Click here)
9. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2GR-FE). (Click here)
Sensor signal check cannot be performed 1. TS and CG terminal circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
DTC check cannot be performed 1. Check for DTCs again and make sure that normal system code displayed. (Click here)
2. TC and CG terminal circuit (Click here)
3. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE). (Click here)
4. If symptoms still occur even after above circuits in suspected areas inspected and proved to be normal, replace ABS and TRACTION actuator (skid control ECU) (for 2GR-FE). (Click here)
ABS warning light abnormal (Remains on) 1. ABS warning light circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
ABS warning light abnormal (Does not come on) 1. ABS warning light circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
BRAKE warning light abnormal (Remains on) 1. BRAKE warning light circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
BRAKE warning light abnormal (Does not come on) 1. BRAKE warning light circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
SLIP indicator light abnormal (Remains on) 1. SLIP indicator light circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
SLIP indicator light abnormal (Does not come on) 1. SLIP indicator light circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
VSC OFF switch abnormal 1. VSC OFF switch circuit (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)
Meter buzzer abnormal 1. Meter / Gauge system (Click here)
2. ABS and TRACTION actuator (skid control ECU) (for 2AZ-FE) (Click here)
3. ABS and TRACTION actuator (skid control ECU) (for 2GR-FE) (Click here)