This DTC is stored when items controlled by the certification ECU cannot be customized via the navigation system vehicle customization screen.
The certification ECU controls the smart entry and start system related items that are customizable via the multi-display screen.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15F7 | Certification ECU vehicle setting processing error. | ·
CAN communication system ·
Smart entry and start system ·
Certification ECU ·
Navigation receiver assembly |
When replacing the navigation receiver assembly, perform vehicle contract setting (See page Audio / Visual / Telematics>G-BOOK>G-BOOK SYSTEM>REGISTRATION).
Before replacing the certification ECU, refer to the Service Bulletin.
Use the intelligent tester to check if the CAN communication system is functioning normally (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
CAN communication DTCs are not output.
OK
NG
Check if the smart entry and start system is malfunctioning (See page Vehicle Interior>DOOR LOCK>SMART ENTRY AND START SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
Customization may not be possible depending on the malfunction in the smart entry and start system.
No malfunctions are present in the smart entry and start system.
OK
NG
(See pageVehicle Interior>DOOR LOCK>SMART ENTRY AND START SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING)
Display the "Door lock settings" screen.
Using the intelligent tester, confirm that it is possible to change the settings of the customize parameters that are available for customization via the multi-display screen.
The items available for customization via the multi-display screen can be customized successfully using the intelligent tester.
OK
NG