Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › from 2014.09
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292216 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2313  Glass Position Initialization Incomplete  


DESCRIPTION

The power window regulator motor is driven by operating the power window switch. The power window regulator motor has motor, regulator and ECU functions.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is set.

HINT:

This DTC may occur for all the windows.


NOTICE:
·

When the power window regulator motor is reinstalled or replaced, the power window control system must be initialized.

·

After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the AUTO UP function is used. In such cases, the AUTO UP function can be resumed by repeating the following operation at least 5 times:

(a)

Close the power window by fully pulling up the power window switch and holding it in the AUTO UP position.

(b)

Open the power window by fully pushing down the switch.




for Driver side
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor not initialized

·

Power window regulator motor malfunctions


·

Power window regulator motor not initialized

·

Power window regulator motor



for Front passenger side
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor not initialized

·

Power window regulator motor malfunctions


·

Power window regulator motor not initialized

·

Power window regulator motor



for Rear LH
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor not initialized

·

Power window regulator motor malfunctions


·

Power window regulator motor not initialized

·

Power window regulator motor



for Rear RH
DTC No. DTC Detection Condition Trouble Area
B2313
·

Power window regulator motor not initialized

·

Power window regulator motor malfunctions


·

Power window regulator motor not initialized

·

Power window regulator motor



PROCEDURE

1.CHECK FOR DTC
a.

Turn the ignition switch on (IG) and initialize the power window regulator motor (see page Vehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


b.

Turn the ignition switch off.


c.

Wait for at least 10 seconds, and then turn the ignition switch on (IG).


d.

Check for DTCs.

Result
Result Proceed to
B2313 is output A
B2313 is not output B



A

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (APPLICABLE LOCATION)

B

END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)