Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292216 POWER WINDOW CONTROL SYSTEM C

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  B2322  Front Passenger Side Door ECU Communication Stop  


DESCRIPTION

DTC B2322 is output when communication between the power window regulator motor (for front passenger side) and main body ECU stops for more than 10 seconds.

DTC No. DTC Detection Condition Trouble Area
B2322 No communication between power window regulator motor (for front passenger side) and main body ECU for more than 10 seconds
·

Power window regulator motor (for front passenger side)

·

Main body ECU

·

Wire harness



WIRING DIAGRAM

B142470E08
0.884,3.032 1.957,3.179 1.073,0.147 10 G59 5.037,3.032 7.072,3.179 2.036,0.147 10 I5*1, J5*2 0.884,3.188 1.957,3.335 1.073,0.147 10 Main Body ECU 5.037,3.188 7.072,3.335 2.036,0.147 10 Power Window Regulator Motor 2.571,0.501 3.364,0.648 0.793,0.147 10 from Battery 4.028,0.819 4.745,0.966 0.716,0.147 10 P/W FL*2 4.028,0.678 4.745,0.825 0.716,0.147 10 P/W FR*1 0.087,3.338 0.838,3.485 0.752,0.147 10 *1: for LHD 0.087,3.56 0.838,3.706 0.752,0.147 10 *2: for RHD 1.376,1.435 1.707,1.581 0.331,0.147 10 LIN2 1.838,1.561 2.170,1.708 0.331,0.147 10 10 5.355,1.561 5.485,1.708 0.130,0.147 10 9 5.355,0.678 5.485,0.825 0.130,0.147 10 2 5.355,2.444 5.485,2.590 0.130,0.147 10 1 5.598,1.435 5.929,1.581 0.331,0.147 10 LIN 5.598,0.52 5.929,0.666 0.331,0.147 10 B 5.598,2.313 5.929,2.459 0.331,0.147 10 GND

PROCEDURE

1.CHECK FOR DTC

b.

Check for DTCs again.

Result
Result Proceed to
B2322 is output A
B2322 is not output B



A

2.INSPECT FUSE (P/W FR, P/W FL)

B

END

2.INSPECT FUSE (P/W FR, P/W FL)
a.

for LHD:

Remove the P/W FR fuse from the instrument panel junction block RH.


b.

for RHD:

Remove the P/W FL fuse from the main body ECU.


c.

Measure the resistance of the fuse.

Standard resistance:

Below 1 Ω




OK

3.CHECK WIRE HARNESS (POWER WINDOW MOTOR - BATTERY AND BODY GROUND)

NG

REPLACE FUSE

3.CHECK WIRE HARNESS (POWER WINDOW MOTOR - BATTERY AND BODY GROUND)
a.
U188630E02
1.906,1.229 2.167,1.229 false 1.26,1.229 1.542,1.229 false 0.083,0.042 1.406,0.26 1.323,0.219 10 false Wire Harness Side: 0.271,1.792 1.052,1.948 0.781,0.156 10 false *2: for RHD 2.208,1.156 2.344,1.302 0.135,0.146 10 false B 0.906,1.146 1.25,1.292 0.344,0.146 10 false GND 0.219,0.906 0.688,1.083 0.469,0.177 10 false J5 0.24,0.625 0.708,0.802 0.469,0.177 10 false I5 0.271,1.479 1.052,1.667 0.781,0.188 10 false *1: for LHD 0.5,0.615 0.969,0.792 0.469,0.177 10 false *1 0.5,0.906 0.969,1.083 0.469,0.177 10 false *2

Disconnect the I5*1 or J5*2 motor connector.


b.

Measure the voltage and resistance of the wire harness side connector.

Standard voltage:
for LHD
Tester Connection Specified Condition
I5-2 (B) - Body ground 10 to 14 V

for RHD
Tester Connection Specified Condition
J5-2 (B) - Body ground 10 to 14 V


Standard resistance:
for LHD
Tester Connection Specified Condition
I5-1 (GND) - Body ground Below 1 Ω

for RHD
Tester Connection Specified Condition
J5-1 (GND) - Body ground Below 1 Ω




OK

4.CHECK WIRE HARNESS (MAIN BODY ECU - POWER WINDOW MOTOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK WIRE HARNESS (MAIN BODY ECU - POWER WINDOW MOTOR)
a.

Disconnect the G59 ECU connector.


b.

Disconnect the I5*1 or J5*2 motor connector.


c.

Measure the resistance of the wire harness side connectors.

Standard resistance:
for LHD
Tester Connection Specified Condition
G59-10 (LIN2) - I5-9 (LIN) Below 1 Ω
G59-10 (LIN2) or I5-9 (LIN) - Body ground 10 kΩ or higher

for RHD
Tester Connection Specified Condition
G59-10 (LIN2) - J5-9 (LIN) Below 1 Ω
G59-10 (LIN2) or J5-9 (LIN) - Body ground 10 kΩ or higher




OK

5.CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

5.CHECK POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side)
a.

Temporarily replace the power window regulator motor with a new or normally functioning one.



NEXT

6.CHECK FOR DTC
6.CHECK FOR DTC

b.

Check for DTCs again.

Result
Result Proceed to
B2322 is not output A
B2322 is output B



A

END (POWER WINDOW REGULATOR MOTOR IS FAULTY)

B

REPLACE MAIN BODY ECU