Home › Vehicle Interior › WINDOW / GLASS › DEFOGGER RELAY
RM24M0E _58 Vehicle Interior _059592 WINDOW / GLASS _0292225 DEFOGGER RELAY G

WINDOW / GLASS  DEFOGGER RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 85912 2.REMOVE DEFOGGER RELAY (Marking: DEF)

a.

Remove the defogger relay from the engine room No. 1 relay block.


Hide 85912 3.INSPECT DEFOGGER RELAY

a.
A087121E50
2.333,0.604 2.333,0.292 false 2.49,1.135 2.958,1.135 false 2.49,1.635 2.958,1.635 false 2.031,0.625 1.854,0.313 false 2.625,0.625 2.802,0.313 false 0.313,1.417 0.51,1.625 0.198,0.208 10 false 1 1.792,0.104 1.99,0.313 0.198,0.208 10 false 1 1.313,1.417 1.51,1.625 0.198,0.208 10 false 2 2.792,0.104 2.99,0.313 0.198,0.208 10 false 2 0.313,0.865 0.51,1.073 0.198,0.208 10 false 3 3.01,1.552 3.208,1.76 0.198,0.208 10 false 3 0.938,0.385 1.135,0.594 0.198,0.208 10 false 4 2.302,0.104 2.5,0.313 0.198,0.208 10 false 4 1.313,0.865 1.51,1.073 0.198,0.208 10 false 5 3.01,1.042 3.208,1.25 0.198,0.208 10 false 5

Measure the resistance of the defogger relay.

Standard resistance:
Tester Connection Specified Condition
3 - 4 Below 1 Ω
3 - 5 10 kΩ or higher
3 - 4 10 kΩ or higher
(when battery voltage is applied to terminals 1 and 2)
3 - 5 Below 1 Ω
(when battery voltage is applied to terminals 1 and 2)


If the result is not as specified, replace the relay.


Hide 85912 4.INSTALL DEFOGGER RELAY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Hide 6.PERFORM INITIALIZATION

a.

Perform initialization (see page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).

NOTICE:

Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.