Use the same procedure for the LH side and RH side.
The procedure listed below is for the LH side.
81740
1.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH
87966
2.REMOVE OUTER MIRROR RETRACTOR
Remove the vinyl tape from the gasket.
Cut the wire harness at the position shown in the illustration.
Remove the gasket.
Using a screwdriver, disengage the 3 claws and remove the lower cover.
Using a T25 "TORX" socket wrench, remove the 3 screws and base.
Make sure to replace the "TORX" screws with new ones.
Disengage the clamp.
Using a T25 "TORX" socket wrench, remove the screw and base plate.
Make sure to replace the "TORX" screws with new ones.
Remove the 3 screws.
Disengage the 2 clamps.
Disconnect the connector and remove the mirror actuator.
When disconnecting the mirror actuator connectors, use a screw driver wrapped with protective tape.
Remove the screw.
Remove the 2 screws.
Disengage the claw.
Slide the guide in the direction indicated by the arrow in the illustration and remove the frame sub-assembly.