1.INSTALL FRONT BUMPER ASSEMBLY
Connect the connector.
Engage the 6 claws and install the front bumper assembly as shown in the illustration.
Install the 3 clips.
Install the 3 screws, 4 bolts and 4 clips.
Install the screw.
Use the same procedure for the RH side and LH side.
Install the pin hold clip.
Make sure that the groove on the pin hold clip is positioned vertically.
Use the same procedure for the RH side and LH side.
53101
2.INSTALL RADIATOR GRILLE SUB-ASSEMBLY
Engage the 6 claws and install the radiator grille sub-assembly.
Install the 2 screws and clip.
53292A
3.INSTALL UPPER RADIATOR SUPPORT SEAL
Install the upper radiator support seal with the 5 clips.
4. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT
5. PREPARE FOG LIGHT AIMING
81210A
6.INSPECT FOG LIGHT AIMING
7.ADJUST FOG LIGHT AIMING