52021
1.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper reinforcement sub-assembly with the 8 bolts.
Install the bolt.
Engage the 5 clamps.
52611
2.INSTALL FRONT BUMPER ENERGY ABSORBER
Engage the 4 guide to install the front bumper energy absorber.
86520
3.INSTALL LOW PITCHED HORN ASSEMBLY
86510
4.INSTALL HIGH PITCHED HORN ASSEMBLY
52116A
5.INSTALL FRONT BUMPER SIDE SUPPORT LH
Engage the claw and install the front bumper side support LH.
Install the 2 screws.
52115A
6.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure for the RH side and LH side.
52127C
7.INSTALL FRONT BUMPER HOLE COVER
Engage the 2 claws and install the fog bumper hole cover.
Use the same procedure for the RH side and LH side.
82114
8.INSTALL NO. 4 ENGINE ROOM WIRE
Engage the 10 clamps to install the NO. 4 engine room wire.
89348A
9.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)
89341A
10.INSTALL NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System)
52128B
11.INSTALL FRONT BUMPER HOLE COVER LH (w/ Cover)
Engage the 3 claws and install the front bumper hole cover LH.
52127D
12.INSTALL FRONT BUMPER HOLE COVER RH (w/ Cover)
Use the same procedure for the RH side and LH side.
53112E
13.INSTALL LOWER NO. 1 RADIATOR GRILLE
Engage the 17 claws and install the lower NO. 1 radiator grille.
81482E
14.INSTALL FOG LIGHT BRACKET LH
Install the clip.
Install the 2 bolts to the fog light bracket LH.
81481G
15.INSTALL FOG LIGHT BRACKET RH
Use the same procedure for the RH side and LH side.
81220
16.INSTALL FOG LIGHT ASSEMBLY LH
81210A
17.INSTALL FOG LIGHT ASSEMBLY RH
Use the same procedure for the RH side and LH side.
85208A
18.INSTALL HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY (w/ Headlight Cleaner System)
85045
19.INSTALL HEADLIGHT WASHER NOZZLE SUB-ASSEMBLY (w/ Headlight Cleaner System)
85376B
20.INSTALL HEADLIGHT CLEANER WASHER HOSE (w/ Headlight Cleaner System)
75311
21.INSTALL RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
Engage the 3 claws and install the radiator grille emblem.
53396D
22.INSTALL RADIATOR GRILLE SEAL
Install 2 new radiator grille seals.
53145B
23.INSTALL RADIATOR GRILLE GARNISH CLIP
Install the 2 radiator grille garnish clips.
53155D
24.INSTALL NO. 1 RADIATOR GRILLE SEAL
Wipe off any tape adhesive residue with cleaner.
Install a new No. 1 radiator grille seal.
Engage the 2 clips.
52114A
25.INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET (for Type B)
Engage the 3 guides and install the front bumper extension mounting bracket as shown in the illustration.
Install the 2 screws.
52114A
26.INSTALL FRONT BUMPER EXTENSION MOUNTING BRACKET (for Type A)
Engage the 2 claws and install the front bumper extension mounting bracket.
Install the 2 screws.