89348A
1.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (for Standard)
Use the same procedure for the RH side and LH side.
for Type A:
| *a | Keyhole |
| *b | Snap |
Engage the 2 claws to install the No. 2 ultrasonic sensor retainer to the front bumper assembly.
Do not damage the front bumper assembly with the protrusion when installing the No. 2 ultrasonic sensor retainer.
Securely install the No. 2 ultrasonic sensor retainer so that there are no gaps between the No. 2 ultrasonic sensor retainer and surface of the front bumper assembly.
When installing the No. 2 ultrasonic sensor retainer, align the keyhole and snap as shown in the illustration.
89341A
2.INSTALL NO. 1 ULTRASONIC SENSOR (for Standard)
Use the same procedure for the RH side and LH side.
for Type A:
Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 2 ultrasonic sensor retainer.
Push the No. 2 ultrasonic sensor retainer from the outside of the front bumper assembly when there is a gap between the No. 2 ultrasonic sensor retainer and the front bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.
Connect the connector.
for Type B:
Engage the 4 claws to install the No. 1 ultrasonic sensor as shown in the illustration.
| *a | Keyhole | - | - |
Do not damage the front bumper assembly.
Do not damage the No. 1 ultrasonic sensor.
Align the keyhole and the connector of the No. 1 ultrasonic sensor as shown in the illustration.
When pressing the No. 1 ultrasonic sensor to engage the claws, apply force perpendicular to the front bumper assembly.
While pressing the No. 1 ultrasonic sensor from the outside of the front bumper assembly, connect the connector.
After connecting the connector, press the No. 1 ultrasonic sensor from the outside of the front bumper assembly.
89348
3.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Sport Package)
Engage the 2 claws to install the No. 1 ultrasonic sensor retainer to the front bumper assembly.
| *A | for LH Side |
| *B | for RH Side |
| *a | Keyhole |
| *b | Snap |
Do not damage the front bumper assembly with the protrusion when installing the No. 1 ultrasonic retainer.
Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the No. 1 ultrasonic sensor retainer and surface of the front bumper assembly.
When installing the No. 1 ultrasonic sensor retainer, align the keyhole and snap as shown in the illustration.
89341A
4.INSTALL NO. 1 ULTRASONIC SENSOR (for Sport Package)
Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.
Push the No. 1 ultrasonic sensor retainer from the outside of the front bumper assembly when there is a gap between the retainer and the front bumper assembly surface. In this case, do not push on the No. 1 ultrasonic sensor.
89348D
5.INSTALL ULTRASONIC SENSOR CLIP (for Sport Package)
Engage the 4 claws to install the ultrasonic sensor clip.
| *A | for LH Side |
| *B | for RH Side |
Engage the clamp.
| *A | for LH Side |
| *B | for RH Side |
Connect the connector.
6.INSTALL FRONT BUMPER ASSEMBLY (for Standard)
7.INSTALL FRONT BUMPER ASSEMBLY (for Sport Package)