53292A
1.REMOVE UPPER RADIATOR SUPPORT SEAL
53101
2.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Put protective tape around the radiator grille sub-assembly.
| *1 | Protective Tape |
Remove the 2 screws and clip.
Disengage the 6 claws and remove the radiator grille sub-assembly.
3.REMOVE FRONT BUMPER ASSEMBLY
Put protective tape around the front bumper assembly.
| *1 | Protective Tape |
Remove the screw.
Use the same procedure for the RH side and LH side.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
Use the same procedure for the RH side and LH side.
Remove the 4 bolts and 3 screws.
Remove the 4 clips.
Remove the 3 clips.
Disengage the 6 claws as shown in the illustration.
Disconnect each connector and remove the front bumper assembly.