52021
1.INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Install the front bumper reinforcement sub-assembly with the 8 bolts.
Install the bolt.
52611
2.INSTALL FRONT BUMPER ENERGY ABSORBER
Engage the 4 guides to install the front bumper energy absorber.
86520
3.INSTALL LOW PITCHED HORN ASSEMBLY
86510
4.INSTALL HIGH PITCHED HORN ASSEMBLY
52116A
5.INSTALL FRONT BUMPER SIDE SUPPORT LH
Engage the 2 claws.
install the front bumper side support LH with the 2 screws.
52115A
6.INSTALL FRONT BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
53879A
7.INSTALL FRONT FENDER LINER RETAINER
Engage the claw and install the front fender liner retainer.
Use the same procedure for the RH side and LH side.
52711
8.INSTALL FRONT BUMPER MOULDING
Engage the 12 claws and install the front bumper moulding.
53112E
9.INSTALL NO. 1 LOWER RADIATOR GRILLE
Engage the 16 claws to install the No. 1 lower radiator grille.
52128C
10.INSTALL FRONT BUMPER HOLE COVER LH
Engage the 4 claws to install the front bumper hole cover LH.
52127C
11.INSTALL FRONT BUMPER HOLE COVER
Use the same procedure as for the LH side.
52128B
12.INSTALL FRONT BUMPER HOLE COVER LH
Engage the hook.
| *1 | Hook |
Engage the 4 claws to install the front bumper hole cover LH.
52127D
13.INSTALL FRONT BUMPER HOLE COVER RH
Use the same procedure as for the LH side.
53155G
14.INSTALL RADIATOR GRILLE SEAL
Wipe off any tape adhesive residue with cleaner.
Install a new radiator grille seal.
Stick the new radiator grille seal on the line marked on the No. 1 lower radiator grille.
Use the same procedure for the RH side and LH side.
52040
15.INSTALL FRONT BUMPER HOLE COVER ASSEMBLY LH
Engage the 2 guides and 4 claws.
Install the front bumper hole cover assembly LH with the 3 clips.
52030
16.INSTALL FRONT BUMPER HOLE COVER ASSEMBLY RH
Use the same procedure as for the LH side.
82114
17.INSTALL NO. 4 ENGINE ROOM WIRE
Engage the 11 clamps to install the No. 4 engine room wire.
81220
18.INSTALL FOG LIGHT ASSEMBLY LH
81210A
19.INSTALL FOG LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
89348
20.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)
89341A
21.INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)
89348D
22.INSTALL ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)
53115B
23.INSTALL RADIATOR GRILLE BRACKET
Engage the 2 claws to install the radiator grille bracket.
Engage the 14 claws to install the outer radiator grille.
53152A
24.INSTALL RADIATOR GRILLE AIR GUIDE
Engage the 3 claws
Install the radiator grille air guide with the 3 screws.
75311
25.INSTALL RADIATOR GRILLE (OR FRONT PANEL) EMBLEM
Engage the 2 guides and 3 claws to install the radiator grille (or front panel) emblem.
53145B
26.INSTALL RADIATOR GRILLE GARNISH CLIP
Install the 2 radiator grille garnish clips.
53155D
27.INSTALL NO. 1 RADIATOR GRILLE SEAL
Wipe off any tape adhesive residue with cleaner.
Engage the 2 clips to install a new No. 1 radiator grille seal.
| *1 | Double-sided Tape |