There may be an open circuit in the CAN main wire and/or the DLC3 branch wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is 70 Ω or more.
| Symptom | Trouble Area |
|---|---|
| Resistance between terminals 6 (CANH) and 14 (CANL) of DLC3 is 70 Ω or more. | ·
CAN main wire and connector ·
No. 1 junction connector ·
No. 2 CAN junction connector LH ·
No. 1 CAN junction connector RH ·
No. 2 junction connector ·
ECM ·
Combination meter ECU |
Turn the engine switch off before measuring the resistances of the main wire and the branch wire.
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Measure the resistance of the DLC3.
| Tester Connection | Condition | Measured Resistance | Proceed to |
|---|---|---|---|
| G15-6 (CANH) - G15-14 (CANL) | Engine switch off | 108 to 132 Ω | A |
| G15-6 (CANH) - G15-14 (CANL) | Engine switch off | 133 Ω or more | B |
When the measured value is 133 Ω or more and a CAN communication system diagnostic trouble code is output, there may be a fault besides disconnection of the DLC3 branch wire. For that reason, troubleshooting should be performed again from "HOW TO PROCEED WITH TROUBLESHOOTING" (see page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING) after repairing the trouble area.
A
B
Disconnect the G74 No. 2 CAN junction connector LH connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G74-1 (CANH) - G74-2 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Disconnect the G73 No. 2 CAN junction connector LH connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G73-1 (CANH) - G73-2 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Reconnect the G74 No. 2 CAN junction connector LH connector.
NEXT
Disconnect the A29 No. 1 junction connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A29-4 (CANH) - A29-7 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A29-3 (CANH) - A29-6 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Reconnect the A29 No. 1 junction connector.
NEXT
Disconnect the A7 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7-41 (CANH) - A7-49 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Reconnect the G73 and G74 No. 2 CAN junction connector LH connectors.
NEXT
Disconnect the N35 No. 2 junction connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N35-1 (CANH) - N35-6 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N35-3 (CANH) - N35-8 (CANL) | Engine switch off | 108 to 132 Ω |
NG
OK
Reconnect the N35 No. 2 junction connector.
NEXT
Disconnect the G28 combination meter ECU connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G28-32 (CANH) - G28-31 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Reconnect the N35 No. 2 junction connector.
NEXT
Disconnect the G78 No. 1 CAN junction connector RH connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G78-1 (CANH) - G78-2 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG
Disconnect the G79 No. 1 CAN junction connector RH connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G79-1 (CANH) - G79-2 (CANL) | Engine switch off | 108 to 132 Ω |
OK
NG