Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM › 2013.04–2016.05
RM24M0E _56 Audio / Visual / Telematics _059566 AUDIO / VIDEO _0291977 AUDIO AND VISUAL SYSTEM Y

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.BASIC INSPECTION
3.BASIC INSPECTION
a.

Turn the engine switch on (ACC).


b.

Check whether or not the display appears on the radio receiver.

Result:
Result Proceed to
Display appears A
Display does not appear B




A

4.CHECK AUDIO MODEL

B

5.CHECK FOR DTC
4.CHECK AUDIO MODEL
a.

Check the audio model.

Result:
Result Proceed to
Premium sound models A
Standard models B




A

5.CHECK FOR DTC

B

8.ADJUST, REPAIR OR REPLACE
5.CHECK FOR DTC
a.

Check for DTCs and note any codes that are output.


b.

Delete the DTC.


c.

Recheck for DTCs. Based on the DTC output in the first step, try to force output of the audio system DTC by simulating the operation indicated by the DTC.

HINT:
·

If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace problem parts.

·

Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores past DTCs.

·

Refer to the detailed description on the diagnostic screen, as necessary (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).

·

Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.



Result:
Result Proceed to
DTC does not reoccur A
DTC reoccurs B




A

6.PROBLEM SYMPTOMS TABLE

B

8.ADJUST, REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B



A

7.OVERALL ANALYSIS AND TROUBLESHOOTING

B

8.ADJUST, REPAIR OR REPLACE
7.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

8.ADJUST, REPAIR OR REPLACE
8.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

END