Use these procedures to troubleshoot the lighting system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>DATA LIST / ACTIVE TEST)
Terminals of ECU (See page Vehicle Interior>LIGHTING>LIGHTING SYSTEM(except LED Headlight)>TERMINALS OF ECU)
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT