Home › Engine / Hybrid System › 2GR-FE STARTING › PUSH-BUTTON START › from 2016.05
RM24M0E _51 Engine / Hybrid System _059574 2GR-FE STARTING _0292073 PUSH-BUTTON START Y

2GR-FE STARTING  PUSH-BUTTON START  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedures to troubleshoot the push-button start function.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS CHECK
2.CUSTOMER PROBLEM ANALYSIS CHECK
HINT:
·

In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points in the problem analysis:

What? Vehicle model, system name
When? Date, time, occurrence frequency
Where? Road conditions
Under what conditions? Running conditions, driving conditions, weather conditions
How did it happen? Problem symptoms



Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN Communication System is functioning normally (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).

Result:
Result Proceed to
CAN DTC is not output A
CAN DTC is output B




A

5.CHECK FOR DTC*

B

GO TO CAN COMMUNICATION SYSTEM

5.CHECK FOR DTC*
a.

Check for DTCs and note any codes that are output (See page Engine / Hybrid System>2GR-FE STARTING>PUSH-BUTTON START>DTC CHECK / CLEAR).


b.

Delete DTCs.


c.

Recheck for DTCs.

Result:
Result Proceed to
DTC does not reoccur A
DTC reoccurs B




A

6.INSPECT BASIC OPERATION

B

GO TO DIAGNOSTIC TROUBLE CODE CHART

6.INSPECT BASIC OPERATION
a.

Turn the engine switch on (START) and check that the engine starts normally. Make sure that the brake pedal is depressed and the shift position is P at this time.


b.

Check that the engine switch mode can be changed by pushing the engine switch.

HINT:

Without depressing the brake pedal, push the engine switch repeatedly. Engine switch mode should turn from off to on (ACC) to on (IG) and back to off.

With the brake pedal depressed, push the engine switch repeatedly. Engine switch mode should turn to ENGINE START from any status.


OK:

Engine starts normally.



Result:
Proceed to
NEXT



NEXT

7.PROBLEM SYMPTOMS TABLE
7.PROBLEM SYMPTOMS TABLE
Result:
Result Proceed to
Fault is not listed in the problem symptoms table A
Fault is listed in the problem symptoms table B



A

8.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

9.REPAIR OR REPLACE
8.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

9.REPAIR OR REPLACE
9.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

10.CONFIRMATION TEST
10.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END