| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the engine switch on (ACC).
Check whether or not the display appears on the radio receiver.
| Result | Proceed to |
|---|---|
| Display appears | A |
| Display does not appear | B |
A
B
Check the audio model.
| Result | Proceed to |
|---|---|
| Premium sound models | A |
| Standard models | B |
A
B
Check for DTCs and note any codes that are output.
Delete the DTC.
Recheck for DTCs. Based on the DTC output in the first step, try to force output of the audio system DTC by simulating the operation indicated by the DTC.
If the system cannot enter the diagnosis mode, inspect each AVC-LAN communication signal and repair or replace problem parts.
Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores past DTCs.
Refer to the detailed description on the diagnostic screen, as necessary (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>DTC CHECK / CLEAR).
Check and clear past diagnostic trouble codes. Check the diagnostic trouble code and inspect the area the code indicates.
| Result | Proceed to |
|---|---|
| DTC does not reoccur | A |
| DTC reoccurs | B |
A
B
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Terminals of ECU (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>TERMINALS OF ECU)
Inspection
Front No. 1 speaker (See page Audio / Visual / Telematics>AUDIO / VIDEO>FRONT SIDE SPEAKER>INSPECTION)
Rear No. 1 speaker (See page Audio / Visual / Telematics>AUDIO / VIDEO>REAR SIDE SPEAKER>INSPECTION)
Roof speaker (See page Audio / Visual / Telematics>AUDIO / VIDEO>ROOF SPEAKER>INSPECTION)
Steering pad switch (See page Audio / Visual / Telematics>AUDIO / VIDEO>STEERING PAD SWITCH>INSPECTION)
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT