*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer and confirm the problem (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).
If DTC C1441 is output, confirm the following conditions:
History of brake fluid replacement.
Whether the engine was stopped intentionally when driving.
Whether the brake and accelerator pedals were depressed simultaneously.
| Proceed to |
|---|
| NEXT |
NEXT
Check and record DTCs and Freeze Frame Data (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR for DTC Check / Clear, and Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA for Freeze Frame Data).
Clear the DTCs and Freeze Frame Data (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR for DTC Check / Clear, and Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA for Freeze Frame Data).
Reconfirm the DTCs.
Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR for DTC Check / Clear, and Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA for Freeze Frame Data).
When CAN communication system DTCs are output, repair the CAN communication system first.
If DTC U0100, U0123 and/or U0126 are among the CAN communication DTCs that are output, first use the Data List to check for a momentary open circuit.
If the GTS cannot communicate with the skid control ECU (brake actuator assembly), inspect the CAN communication system.
If there is no response from the skid control ECU (brake actuator assembly), inspect the +BS circuit of the skid control ECU (brake actuator assembly).
| Result | Proceed to |
|---|---|
| DTCs are not output. (Problem symptom does not occur.) | A |
| DTCs are not output. (Problem symptom occur.) | B |
| DTCs are output. | C |
A
B
C
Proceed to Diagnostic Trouble Code Chart (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to How to Proceed with Troubleshooting.
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to Problem Symptoms Table (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE).
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs (See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
Check if the same DTCs are output (See pageBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT