2011-2016 FJ Cruiser · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. INSTALL NO. 1 COOLER THERMISTOR

I102463E01
  1. Install the sensor onto the evaporator as shown in the illustration.

  1. Check that the sensor sticks to the evaporator surface as shown in the illustration (A: Sensor, B: Evaporator).

    NOTICE:
    If reusing the evaporator, do not reinsert the sensor in the same position that it was in before. Insert it within area C shown in the illustration.


2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

I102461
  1. Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the cooler evaporator.

    Compressor oil:
    ND-OIL8 or the equivalent

  1. Install the 2 O-rings onto the cooler evaporator.

  1. Install the cooler evaporator.

    HINT:
    If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows.

    Compressor oil:
    ND-OIL8 or the equivalent. Add 40 cc (1.35 fl. oz.)

  1. Install the cooler evaporator onto the heater case.

  1. I102460
    Install the heater case with the 8 screws.

  1. I102459
    Install the plate with the 2 screws.


3. INSTALL COOLER EXPANSION VALVE

I102458
  1. Apply sufficient compressor oil (ND-OIL8) to the fitting surface of the cooler expansion valve.

    Compressor oil:
    ND-OIL8 or the equivalent

  1. Install the cooler expansion valve onto the cooler evaporator.


4. INSTALL AIR CONDITIONING TUBE ASSEMBLY

I102457
  1. Apply sufficient compressor oil (ND-OIL8) to 2 new O-rings and the fitting surface of the air conditioning tube.

    Compressor oil:
    ND-OIL8 or the equivalent

  1. Install the 2 O-rings onto the air conditioning tube.

  1. Using a hexagon wrench 4, install the air conditioning tube with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 36 kgf*cm , 31 in.*lbf }


5. INSTALL COVER PLATE

  1. I102456
    Engage the claw.

  1. Install the cover plate with the screw.


6. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

I102454
  1. Install the heater radiator unit onto the heater case.

  1. Install the clamp with the screw.


7. INSTALL COOLER UNIT DRAIN HOSE

  1. I102455
    Install the cooler unit drain hose.


8. INSTALL AIR MIX CONTROL SERVO MOTOR

  1. I102452
    Install the air mix control servo motor with the 3 screws.


9. INSTALL MODE CONTROL SERVO MOTOR

  1. I102451
    Install the mode control servo motor with the 3 screws.

← INSPECTION (from Jul 2007)REASSEMBLY (from Nov 2010) →