2011-2016 FJ Cruiser · Service Manual ENGINE

P0116 Engine Coolant Temperature Circuit Range / Performance Problem

Diagnostic trouble codes · Vehicles built Dec 2007 – Jul 2009

Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014

DESCRIPTION

Refer to DTC P0115 (Click here).
DTC No.
DTC Detection Conditions
Trouble Areas
P0116
Engine Coolant Temperature (ECT) between 35°C and 60°C (95°F and 140°F) when engine started, and conditions (a) and (b) met (2 trip detection logic):
(a) Vehicle driven at varying speeds (accelerated and decelerated)
(b) ECT remains within 3°C (5.4°F) of initial ECT
  1. Thermostat
  2. ECT sensor
  3. Cooling system

MONITOR DESCRIPTION

The ECT sensor is used to monitor the ECT. The ECT sensor has a thermistor that varies its resistance depending on the temperature of the engine coolant. When the ECT is low, the resistance in the thermistor increases. When the temperature is high, the resistance decreases. The variations in resistance are reflected in the output voltage from the sensor. The ECM monitors the sensor voltage and uses this value to calculate the ECT. When the sensor output voltage deviates from the normal operating range, the ECM interprets this as a fault in the ECT sensor and sets the DTC.
Examples:
Upon starting the engine, the ECT is between 35°C and 60°C (95°F and 140°F). If after driving for 250 seconds, the ECT still remains within 3°C (5.4°F) of the starting temperature, a DTC is set (2 trip detection logic).

INSPECTION PROCEDURE

HINT:
  1. If any of DTCs P0115, P0117, P0118 or P0125 are set simultaneously with DTC P0116, the ECT sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  2. Read freeze frame data using an intelligent tester. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data, from the time the malfunction occurred.


1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
  1. Connect an intelligent tester to the DLC3.

  1. Turn the ignition switch ON.

  1. Turn the tester ON.

  1. Select the following menu items: Powertrain / Engine and ECT / DTC.

  1. Read DTCs.

Result:
Display (DTC Output)
Proceed To
P0116
A
P0116 and other DTCs
B



B
GO TO DTC CHART (Click here)
A


2. INSPECT WATER INLET WITH THERMOSTAT
  1. Remove the water inlet with thermostat (Click here).

  1. Check the valve opening temperature of the thermostat.

    Standard:
    80°C to 84°C (176°F to 183°F)

    HINT:
    In addition to the above check, confirm that the valve is completely closed when the temperature is below the standard.

  1. Reinstall the water inlet with thermostat (Click here).



NG
REPLACE WATER INLET WITH THERMOSTAT (Click here)
OK

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (Click here)


← P0116 Engine Coolant Temperature Circuit Range / Performance Problem (Jul 2007 – Nov 2007)P0116 Engine Coolant Temperature Circuit Range / Performance Problem (Aug 2009 – Oct 2010) →