2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built from Jul 2007


READ DATA LIST

HINT:
Using the intelligent tester's DATA LIST allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the DATA LIST early in troubleshooting is one way to save time.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the tester on.

  4. Read the DATA LIST according to the prompts displayed on the tester.

    BACK-DOOR: 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Wiper Turn Position SW
    Rear wiper turn position switch signal/ON or OFF
    ON: Rear wiper in turning position
    OFF: Rear wiper in other position
    -
    Wiper Retracting SW
    Rear wiper retracting switch signal/ON or OFF
    ON: Rear wiper in retracting position
    OFF: Rear wiper in other position
    -
    Power Window Position
    Back window courtesy switch signal/ON or OFF
    ON: Back window door is open
    OFF: Back window door is closed
    -


PERFORM ACTIVE TEST

HINT:
Performing the tester's ACTIVE TEST allows relays, VSVs, actuators, and other items to be operated without removing any parts. Performing the ACTIVE TEST early in troubleshooting is one way to save time. The DATA LIST can be displayed during the ACTIVE TEST.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch ON.

  3. Turn the tester on.

  4. Perform the ACTIVE TEST according to the prompts displayed on the tester.

    BACK-DOOR: 
    Tester Display
    Test Part
    Control Range
    Normal Condition
    Rear Wiper
    Rear wiper
    ON/OFF
    -

← TERMINALS OF ECU (from Nov 2010)Rear Wiper Motor Circuit (Jul 2007 – Jul 2009) →