2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

Cruise Main Indicator Light Circuit

Circuit diagnosis · Vehicles built Dec 2007 – Jul 2009

Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014

DESCRIPTION

When the cruise control main switch is turned off, cruise control does not operate.

WIRING DIAGRAM

B133356E02

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (ECM - BATTERY)

  1. B133346E02
    Disconnect the E46 ECM connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    PI (E46-18) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Reconnect the ECM connector.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
NG


2. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)

  1. B133358E01
    Disconnect the E46 ECM connector.

  1. Disconnect the combination meter E14 connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Specified Condition
    E14-4 - PI (E46-18)
    Below 1Ω
    E14-4 - Body ground
    10 kΩ or higher

  1. Reconnect the combination meter connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER ASSEMBLY - ECM)
OK


3. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - BATTERY)

  1. B133359E01
    Disconnect the E13 combination meter connector.

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E13-2 - Body ground
    Ignition switch ON
    11 to 14 V

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (COMBINATION METER - BATTERY)
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Cruise Main Indicator Light Circuit (Jul 2007 – Nov 2007)Cruise Main Indicator Light Circuit (Aug 2009 – Oct 2010) →