Cruise Main Indicator Light Circuit
Circuit diagnosis · Vehicles built Nov 2010 – Jul 2011
Versions by build date: Jul 2007 – Nov 2007 Dec 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 Nov 2012 – Jul 2014 from Aug 2014
DESCRIPTION
- When the ECM detects a cruise control switch on signal from the cruise control switch, the ECM sends the signal to the combination meter assembly through CAN communication. Then the cruise control indicator light turns on.
- The cruise control indicator light circuit uses CAN communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.
INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER (CRUISE MAIN INDICATOR LIGHT) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Combination Meter / Active Test.
According to the display on the intelligent tester, perform the Active Test.
Combination Meter Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. Lamp Cruise
Cruise main indicator light
ON/OFF
Confirm that the vehicle is stopped with the engine idling.
- OK:
- Cruise main indicator light turns on/off.
|
|
||||
| OK | |
| 2. READ VALUE USING INTELLIGENT TESTER (CRUISE CONTROL SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Powertrain / Cruise Control / Data List.
According to the display on the intelligent tester, read the Data List.
Cruise Control Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Main SW M-CPU
Cruise control switch (Main CPU) / OFF or ON
OFF: Cruise control switch off
ON: Cruise control switch on
-
- OK:
- On screen, item changes between ON and OFF according to above chart.
|
|
||||
| OK | ||
| ||
