2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

DATA LIST / ACTIVE TEST

System information · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010


READ DATA LIST

HINT:
Using a intelligent tester to read the DATA LIST allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect a intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester ON.

  4. Enter the following menus: Powertrain / Cruise Control / Data List.

  5. According to the display on tester, read the "DATA LIST".

ECM (Cruise Control) 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
CCS Vehicle Spd
Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph)
Actual vehicle speed
-
CCS Mem Vehicle Spd
Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph)
Actual vehicle speed stored in memory
-
Cruise Operation Status
Cruise control / ON or OFF
ON: Cruise control is SET
OFF: Cruise control is UNSET
-
CRUISE CONTROL
Cruise control / ON or OFF
ON: Cruise control is SET
OFF: Cruise control is UNSET
-
CCS Indicator M-CPU
Switch indicator (Main CPU) / ON or OFF
ON: Switch indicator (Main CPU) is SET
OFF: Switch indicator (Main CPU) is UNSET
-
CCS Ready M-CPU
Switch ready (Main CPU) / ON or OFF
ON: Switch ready (Main CPU) is SET
OFF: Switch ready (Main CPU) is UNSET
-
CCS Main SW M-CPU
Main switch (Main CPU) / ON or OFF
ON: Main switch (Main CPU) is SET
OFF: Main switch (Main CPU) is UNSET
-
Cancel Switch
CANCEL switch / ON or OFF
ON: CANCEL switch is SET
OFF: CANCEL switch is UNSET
-
SET/COAST Switch
- / SET switch / ON or OFF
ON: - / SET switch is SET
OFF: - / SET switch is UNSET
-
RES/ACC Switch
+ / RES switch / ON or OFF
ON: + / RES switch is SET
OFF: + / RES switch is UNSET
-
Stp Light SW M-CPU
Stop light switch signal (Main CPU) / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Cruise Request Torque
Cruise control request torque / min.: -1,024 Nm, max.: 1,016 Nm
Actual required torque
-
# Codes
Number of diagnosis codes/Min.: 0, Max.: 255
-
-
← FAIL-SAFE CHART (from Jul 2007)DATA LIST / ACTIVE TEST (Aug 2009 – Oct 2010) →