2011-2016 FJ Cruiser · Service Manual CRUISE CONTROL SYSTEM

DATA LIST / ACTIVE TEST

System information · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010


READ DATA LIST

HINT:
Using a intelligent tester to read the DATA LIST allows values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect a intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the tester on.

  4. Enter the following menus: Powertrain / Cruise Control / Data List.

  5. According to the display on tester, read the "DATA LIST".

ECM (Cruise Control) 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
CCS Vehicle Spd
Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph)
Actual vehicle speed
-
CCS Mem Vehicle Spd
Vehicle speed / min.: 0 km/h (0 mph) max.: 255 km/h (158 mph)
Actual vehicle speed stored in memory
-
Throttle Opening Angle
Throttle opening angle / Min.: 0° Max.: 124.5°
Actual demanded throttle angle
-
Cruise Control
Cruise control / ON or OFF
ON: Cruise control is SET
OFF: Cruise control is UNSET
-
Main SW M-CPU
Main switch signal (Main CPU) / ON or OFF
ON: Main switch on
OFF: Main switch off
3
CCS Ready M-CPU
Cruise control system standby condition (Main CPU) / ON or OFF
Each time main switch is pushed, ON/OFF changes
1
CCS Indicator M-CPU
Cruise main indicator signal (Main CPU) / ON or OFF
ON: Cruise main indicator light on
OFF: Cruise main indicator light off
-
Cancel Switch
CANCEL switch signal / ON or OFF
ON: CANCEL switch on
OFF: CANCEL switch off
-
SET/COAST Switch
-SET/COAST switch signal / ON or OFF
ON: -SET switch on
OFF: -SET switch off
-
RES/ACC Switch
+RES/ACC switch signal / ON or OFF
ON: +RES switch on
OFF: +RES switch off
-
Stp Light SW M-CPU
Stop light switch signal (Main CPU) / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
Cruise Operation Status*1
Park/neutral position switch signal (D or 4 position) / ON or OFF
ON: Shift lever in D or 4
OFF: Shift lever not in D or 4
-
Cruise Operation Status*2
Clutch switch signal / ON or OFF
ON: Clutch pedal depressed
OFF: Clutch pedal released
-
Brake Cancel Switch
Brake Cancel signal / ON or OFF
ON: Brake pedal depressed
OFF: Brake pedal released
-
  1. *1: Automatic Transmission
  2. *2: Manual Transmission
  1. 3 is OK but 1 is NG → ECM failure
  2. 1 is OK but 2 is NG → DTC output or ECM failure
  3. 3 is OK but the cruise main indicator light does not illuminate → Cruise main indicator light, wire harness, or ECM failure
← DATA LIST / ACTIVE TEST (Jul 2007 – Jul 2009)DATA LIST / ACTIVE TEST (from Nov 2010) →