Remove the 4 screws and the amplifier box speaker.
15.
REMOVE PACKAGE HOLDER NET HOOK
HINT:
Use the same procedure to remove all the package holder net hooks.
Text in Illustration
*a
for RH Side without Woofer
*b
for LH Side
Remove the screw and the package holder net hook.
16.
REMOVE QUARTER TRIM POCKET TRAY (w/o Woofer)
Disengage the 7 claws and remove the quarter trim pocket tray.
17.
REMOVE SIDE TRIM COVER (w/o Woofer)
Disengage the 6 claws and the 2 guides and remove the side trim cover.
18.
REMOVE QUARTER TRIM POCKET (w/o Woofer)
Disengage the 6 claws and remove the quarter trim pocket.
19.
REMOVE LAP BELT OUTER ANCHOR COVER
HINT:
Use the same procedure for both sides.
Text in Illustration
*a
for RH Side
*b
for LH Side
Disengage the 3 claws and remove the lap belt outer anchor cover.
20.
REMOVE REAR SEAT OUTER BELT ASSEMBLY
HINT:
Use the same procedure as for the RH side.
21.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
Remove the 3 screws and the bolt.
Disengage the 6 clips and the 8 claws and remove the deck trim side panel.
w/ Rear Power Outlet Socket:
Disconnect the 2 connectors.
22.
REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
Remove the 3 screws.
Disengage the 6 clips and the 8 claws and remove the deck trim side panel.
23.
REMOVE ROOF SIDE INNER GARNISH
HINT:
Use the same procedure as for the RH side.
24.
REMOVE BACK DOOR HINGE PROTECTOR LH
Using an infrared light, heat the bake door hinge protector LH.
Text in Illustration
*1
Double-sided Tape
Heating Temperature
Item
Temperature
Vehicle Body
40 to 60°C (104 to 140°F)
CAUTION:
Do not burn yourself on the hot body panel or with the infrared light.
NOTICE:
Do not heat the vehicle body excessively.
Remove any tape remaining on the back door panel.
Pull out the bake door hinge protector LH with the door closed, and then remove the bake door hinge protector LH while peeling off the double-sided adhesive tape.
25.
REMOVE QUARTER WINDOW GLASS
Apply protective tape to the outer circumference of the quarter window, as shown in the illustration.
Text in Illustration
*1
Protective Tape
*2
Piano Wire
From the interior, insert piano wires between the vehicle body and quarter window, as shown in the illustration.
Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.
NOTICE:
When separating the quarter window from the vehicle, do not damage the vehicle's paintwork or exterior/interior ornaments.
Cut through the adhesive by pulling the piano wire around the quarter window.