2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Back Door Courtesy Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Aug 2008 – Oct 2010 from Nov 2010

DESCRIPTION

The inner rear view mirror assembly receives the back door open/close signal from the back door courtesy switch.

WIRING DIAGRAM

E173296E02

INSPECTION PROCEDURE


1. READ VALUE USING TECHSTREAM (LUGGAGE COURTESY SW)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Body / Data List /

  1. According to the display on tester, read the "Data List".

    Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Luggage Courtesy SW
    Back door and back window courtesy switch signal/ON or OFF
    ON: Either back door or back window open
    OFF: Both back door and back window closed
    -

    OK:
    Condition sign can be displayed.



NG
GO TO LIGHTING SYSTEM (DOOR COURTESY SWITCH CIRCUIT) (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (BACK DOOR COURTESY SWITCH - INNER REAR VIEW MIRROR)
E168285E02
  1. Disconnect the R6 inner rear view mirror connector.

  1. Measure the resistance according value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R6-10 - Body ground
    Back door is open
    Below 1 Ω
    R6-10 - Body ground
    Back door is closed
    10 kΩ or higher

  1. Reconnect the R6 inner rear view mirror connector.

    HINT:
    The circuit has diodes, so reverse the two leads and check again.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Back Door Courtesy Switch Circuit (Aug 2008 – Oct 2010)Reverse Signal Circuit (from Aug 2008) →